/*
 * LCD communicates with ILI9341V LCD controller over 4 wire SPI.
 * 
 * When load=1 and in[8]=0 transmission of byte in[7:0] is initiated.
 * CSX is goes low (and stays low even when transmission is completed).
 * DCX is set to in[9]. The byte in[7:0] is send to SDO bitwise together
 * with 8 clock signals on SCK. During transmission out[15] is 1.
 * After 16 clock cycles transmission is completed and out[15] is set to 0.
 * 
 * When load=1 and in[8]=1 CSX goes high and DCX=in[9] without transmission
 * of any bit.
 * 
 * When load16=1 transmission of word in[15:0] is initiated. CSX is goes low
 * (and stays low even when transmission is completed). DCX is set to 1 (data).
 * After 32 clock cycles transmission is completed and out[15] is set to 0.
*/
`default_nettype none
module LCD(
		input clk,			//clock 25 MHz
		input load,		    //start send command/byte over SPI
		input load16,		//start send data (16 bits)
		input [15:0] in,	//data to be send
		output [15:0] out,	//data to be send
		output DCX,			//SPI data/command not
		output CSX,			//SPI chip select not
		output SDO,			//SPI serial data out
		output SCK			//SPI serial clock
);

	// Put your code here:	

endmodule